Shanghai Huawei Welding & Cutting Machine Co., Ltd. Banner
Product Center
Big HCM-200  Portable Track-Guided Flame Oxy-fuel Cutting Machine VCM image
  • Small HCM-200  Portable Track-Guided Flame Oxy-fuel Cutting Machine VCM image
  • Small HCM-200  Portable Track-Guided Flame Oxy-fuel Cutting Machine VCM image
  • Small HCM-200  Portable Track-Guided Flame Oxy-fuel Cutting Machine VCM image

HCM-200 Portable Track-Guided Flame Oxy-fuel Cutting Machine VCM

The HCM-200 is a tough, ruggedly constructed cutting machine, yet compact and light enough that it may be taken to the work site, wherever it may be. It is a versatile, economic, basic guidance system that can be used for oxy-fuel flame cutting, or movement of special equipment setups. It is suitable for field jobs and repair work plus straight line and circle cutting operations required in metalfabrication.

Video
Description

Secure the single torch mount post

(1) the outer case mounting surface with four Allen-head cap screws. Slip the rack handle assembly

(2)over the torch mount post and secure it with the set screw. The rack handle assembly is free to rotate until the clamping bolt is tightened. Insert racking bar assembly

(3) so that the rack properly engages the pinion gear in the rack handle assembly. Connect the torch holder assembly

(4) to the torch pivot knuckle

(5) which fits over the round end of the racking bar assembly. Leave clamping screw, provided at each of these points, slightly loose for adjustment. Then, tighten securely after positioning adjustments are made.

Insert the cutting torch

(6) into the torch holder so that the torch rack properly engages the adjusting gear of the torch holder. Tighten the torch holder. Tighten the torch holder wing nuts enough to hold the torch securely, yet permit vertical adjustment of the torch in the torch holder with the adjusting knob. Use either two-hose or three-hose torches.

Insert the manifold block

(7) in the end of the rack handle assembly. Screw the proper hose adapters into the inlets of the manifold block. Use fuel gas hose adapters in the center pair of holes and oxygen hose adapters in the outer two pairs of holes. Connect the required hoses from the manifold block to the cutting torch. If using a two-hose cutting torch, omit the right-hand hose.

Technical specification

MACHINE SPECIFICATIONS 

Outline Dimensions

Outline dimensions are shown in Figure 1,below.

Capacities

Cutting Length: Increments of 72”(1829mm)

Circle Diameter: 4”to 96”(102 to 2438 mm)

Speed Range

HCM-200 and HCM-200HT: 1 to 60 inches per minute (25 to 1524 mm per minute )

HCM-200HS: 5 to 120 inches per minute (127 to 3048 mmper minute)

Power Requirements

115V.42A 60HZ, Single phase E Models;200V.23A 50HZ/.21A60HZ,single phase

Weights

Tractor Unit alone: 30.5 lbs (13.8Kg)

Tractor Unit with rigging: 37.5 lbs (17.0Kg)

Product inquiry